Call size guide
IF YOU HAVE A PRINTER
- Right-click on the image above and select 'Save Image As.'
- Print the image at 100% scale (make sure scaling is turned off).
- Measure the gray bottom section - it should be 3.5 inches from end to end.
- Cut out the size guide (the upper part) and wrap the paper around the desired finger.
- The number closest to ' Read Size Here ' will be your size (Note: if you are in between two sizes, it is best to round up one size).
Ring size table
| Size | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | |
|---|---|---|---|---|---|---|---|---|---|---|
| Length (mm) | 47 | 49 | 52 | 55 | 57 | 60 | 62 | 65 | 67 | 70 |
If you don't have a printer
- Cut a thin strip of paper, about 10-12 cm long.
- Wrap the paper strip tightly around the desired finger.
- Use a pen or pencil to mark the point where the paper overlaps itself.
- Lay the paper strip on a flat surface and use a ruler to measure the distance from the end of the strip to the mark you made, in millimeters. This will give you a measurement of the circumference of your finger.
- Use the chart below to convert your measurement to our standard ring sizes.
- If you're two sizes up, it's always best to round up rather than down.